Free next working day delivery if ordered by 2pm
Sika Patio Seal 5L
Sika Patio Seal is an easily applied, low odour, water-based sealer and appearance enhancer for new and recently cleaned paving. Ideal for all types of new and recently cleaned concrete and stonework such as vehicle and pedestrian areas, drives, patio and leisure areas, walkways and paths.
- Non-flammable
- Low odour
- Dries clear
- Low sheen, dirt resistant finish
- Acts as a dustproofer and facilitates easier cleaning
- Contains a fungicide to prevent unsightly mould growth
- Easily cleaned with a simple detergent wash
Product Description
Sika Patio Seal is a low odour water based acrylic coating used to seal and protect patios, paths, natural stone, concrete and block paving from the effects of sunlight, water, oil, petrol and organic growth. The milky solution dries to a hard wearing water repellent film which gives a low sheen slip resistant finish which will reduce dirt pickup and facilitate easier cleaning.
The product is safer to use than conventional solvent based products, i.e. it is non- flammable and will not harm plants and animals when used as directed.
Consumption is approx. 1 Litre for 4m – 8m2
Characteristics and Advantages of Sika Patio Sealer
- Water based formulation – non-flammable, low odour.
- Improves appearance of paths/stone.
- Also acts as a dustproofer and facilitates easier cleaning.
- Dramatically improves water and mark resistance – High degree of water repellency in dried film.
- Contains a fungicide – prevents unsightly growth in the film
- Easily cleaned with a simple detergent wash.
Uses for Patio Sealer
- Paths
- Patios
- Natural stone
- Concrete and block paving where it will protect from the effects of sunlight, water, oil, petrol and organic growth.
Application Instructions
Surfaces must be free from grease, dust, loose material, algae etc. Clean surfaces with Sika Mould Buster. For bad oil stains, use a proprietary agent and hot water. For very badly soiled surfaces, use Sika Brick Cleaner. In all cases, wash down the cleaned surface with a hose and broom to remove all traces of cleaning product.
All artificial stone (cement based) and all block pavers must be left for three months minimum after placing before over coating with this product. This will allow salts to leach out which otherwise may cause unsightly white patches appearing beneath the sealer, especially when the patio is wet.
Stir well before use. May be applied to damp (but not wet) surfaces. Apply using a long pile roller and tray or low-pressure spray. Ensure even and thorough age, especially on textured finishes where ponding of the material MUST be avoided. Apply in two coats, lowing no more than 2 hours between coats. An extra coat may be applied if a semi gloss finish is required.
Drying time will be 4 hours from last coat at 20°C. This will be extended at lower temperatures. Do not apply below 5°C.
